Homeowner
These shutter magnet magnets were exactly what I need to replace old, deteriorated shutter magnets that were installed with my shutters. They were for a pair of Quarter Moon or circle and part of a semi-circle window above my bedroom shutters. So far that are spot on for what I needed.
However, one caveat is that the width between screw holes on the magnet were just a bit wide. My fis was to glue a piece of a wood toothpick into one hole and let dry. Then I inserted one screw into the original hole and tighten it down enough so i could drill a small starter hole next to the toothpick for the second screw. Tighten both screws and went on the the next location Still worth a 5 Star rating as it is always good to insure that at least one screw in a bit tighter than the other one.
Did you find this helpful?
Reviewed by: William from Franklin.
on 8/17/2021
5