---

SWAGING
The forming of one or both leaves toward or beyond the center of the pin, swaging slightly increases leaf width.

 

---

BOTH LEAVES HALF-SWAGED
Both leaves are swaged approximately one-half the pin diameter with a minimum clearance between leaves when parallel.

 

---

ONE LEAF HALF-SWAGED
One leaf swaged one half the pin diameter.

 

 

---

ONE LEAF FULL-SWAGED
One leaf swaged equal to the pin diameter and both leaves parallel when in a closed position.

 

---

REVERSE SWAGED
One leaf swaged to simulate reverse assembly. Leaves will not close to a parallel position.

 

 

---

OFFSET
Forming one or both leaves away from the center of the pin. Offsetting slightly decreases leaf width.

 

---

STOP HINGE
A hinge manufactured to limit the travel of the leaves to a specified angle.

 

INSIDE STOP HINGE
Leaves will open from a closed position, leaves parallel to each other, to a stop angle as specified.

 

OUTSIDE STOP HINGE
Leaves move from an open or flat position and stop at a specified angle.